Loading ...
Loading ...
Loading ...
4
English
Installation
What’s in the Box
Make sure all the following items are included in the
packaging. If any items are damaged or missing, contact your
dealer.
RV Range Hood:
● 12V RV Range Hood
● Mounting Screws (4 pieces)
● Instruction Manual
● Warranty Leaflet
Exterior Wall Vent (Sold Separately)
● Exterior Wall Vent
● Mounting Screws (6 pieces)
● Instruction Manual
● Warranty Leaflet
NOTE: If a Furrion exterior wall vent is purchased: please
refer to the user manual IG-FHA00010 for the installation.
The installation should conform to these installation
instructions and with the standards for recreational vehicles,
NFPA 1192.
IMPORTANT
Observe all governing codes and ordinaces.
It is the installer’s responsibility to comply with installation
clearances specified on the model/serial/rating plate. The
model/serial/rating plate is located inside the range hood;
Range hood location should be away from strong draft
areas, such as windows, doors, and strong heating vents.
Models that are capable of being installed as ducted require
charcoal filters.
WARNING
Installation of this appliance must be made in accordance
with the written instructions provided in this manual. No
agent, representative or employee of Furrion or other
persons has the authority to change, modify or waive any
provision of the instructions contained in this manual.
Range Hood Installation
Disconnect power.
WARNING
Electrical Shock Hazard.
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
Electrical Requirements
Observe all governing codes and ordinaces.
Ensure that the electrical installation is adequate and in
conformance with National Electrical Code, ANSI/NFPA
70 (lastest edition), or CSA Standards C22.1-94, Canadian
Elec trical Code, Part 1 and C22.2 No. 0-M91 (lastest edition)
and local codes and ordinances.
If codes permit and a separate ground wire is used, it is
recommended that a qualified electrician determine that the
ground path is adequate.
Wire sizes and connections must confirm with the rating of
the appliance as specified on the model/serial/rating plate.
The model/serial/rating plate is located inside the range
hood. Wire sizes must confirm to the requirements of the
National Electrical Code, ANSI/NFPA 70 (lastest edition), or
CSA Standards C22.1-94, Canadian Electrical Code, Part 1
and C22.2 No. 0-M91 (lastest edition) and local codes and
ordinances.
Recreational vehicle fan units.
Do not operate any fan with a damaged cord or plug. Discard
fan or return to an authorized service facility for examination
and/or repair.
Product Dimensions (Fig. 1)
16⁄”
424.0mm
12”
305.0mm
⅜”
10.0mm
4¾”
120.0mm
23 ½”
597.5mm
6 ¾”
171.5mm
½”
12.7mm
1 ⁄”
40.0mm
Fig. 1
1. Take out the range hood from box and put on a flat surface
with the grill cover facing up.
2. Press the two release tabs on the grill cover to release it from
range hood. (Fig. 2)
Fig. 2
Loading ...
Loading ...
Loading ...