Loading ...
Loading ...
Loading ...
Fig. 14
Fig. 15
Fig. 16
Fig. 13
STIEBEL ELTRON
13
Installation Instruction for the qualied installer
- In the case of laying the cable from
above and from the side, create an opening
for the electric cable using a pair of pliers to
pinch or break the plastic chip on the side or
on the top of the heater as appropriate, so
that the cable is tightly secured to the unit.
- Insert the cable through the rubber
seal at the rear of the unit. Please ensure
that the power is turned o at the mains.
- A circuit breaker or power control
switch should be installed before the unit.
The size of the circuit breaker must corre-
spond to the voltage of the heater (check
the size of the circuit breaker in the
Technical Information section).
- Hang the heater on the screws
mounted on the wall, and slide the heater
down into position.
- Measure and cut the insulation at the
end of the wire in preparation.
- Insert the wires into the respective
openings according to the diagram, and fasten
the screws to secure the wires tightly. Please en-
sure that the correct size of wire is used.
Loading ...
Loading ...
Loading ...