Loading ...
Loading ...
Loading ...
8
REMOTE CONTROL FUNCTIONS
Pressing the On/Off Button
When the air conditioner is not in operation, the remote control
displays the last set point and mode.
S Press ON/OFF to start the unit.
− The unit starts in the last operating mode and set
point. The ON/OFF indicator appears.
S Press On/Off to stop the unit.
− All the indicator lights on the unit go out, and the remote
control displays the set point and mode.
NOTE: If the On/Off button is pressed too soon after a stop, the
compressor will not start for 3 to 4 minutes due to the inherent
protection against frequent compressor cycling. The unit only
emits an audible beep when the signals are received correctly.
Selecting an Operating Mode
Use OPERATING mode to select one of the available modes.
Fig. 8 − Display
Setting the Room Temperature Set Point
Press the increase temperature set point ▲ and decrease ▼ buttons
to raise or lower the temperature.
The unit confirms the signal receipt with a beep and the value
of the set temperature appears on the display and changes
accordingly. The temperature can be set between 62_F (17_C)
and 86_F (30_C) in increments of 1_F or 1_C.
NOTE: In the COOLING mode, if the temperature selected is
higher than the room temperature, the unit will not start. The
same applies for the HEATING mode if the selected
temperature is lower than the room temperature.
Selecting the Fan Speed
AUTO
LOW
MED
HIGH
A14362
Fig. 9 − Fan Speeds
The fan speed can be selected by pressing FAN.
NOTE: When the unit is on, the fan runs continuously in
cooling or heating. When in heating, there might be situations
where the fan will slow down or shut off to prevent cold blow.
Selecting the Up−Down Airflow Louver Position
To optimize comfort, the horizontal louver should be adjusted as
shown below.
When COOLING
Adjust the up−down airflow louver downwards or horizontally
(see Fig. 10).
A150658
Fig. 10 − Air flow
When HEATING
Adjust the up−down airflow louver vertically (see Fig. 11).
A150659
Fig. 11 − Air flow
The horizontal up−down airflow louvers can be adjusted by
pressing DIRECT on the remote control. Press SWING to set the
louvers to a stationary position or to move continuously. The
up−down airflow louver position is stored in the settings, however
it is deactivated when the TURBO or MANUAL settings are set,
or when a power interruption takes place.
Air Direction
Press DIRECT repeatedly to choose one of the up−down airflow
louver positions. Every time DIRECT is pushed, the specific
louver swings 30 degrees.
In the COOLING, DEHUMIDIFICATION, and FAN ONLY
modes, the up−down airflow louver swings in the cooling range.
In the HEATING mode, the louver swings in the heating range.
NOTE: Always use the remote control to adjust the up−down
airflow louver position, otherwise abnormal operation may
occur. If the horizontal louver is manually adjusted out of its
range, power the unit off and then back on again.
Loading ...
Loading ...
Loading ...