Loading ...
Loading ...
Loading ...
Frequently Asked Questions
Problem Possible cause and solution
and continue to
flash after a program
has been canceled, de-
spite thorough cleaning.
The plinth filter looks clean after thorough cleaning.
However, the program terminates and the fault
message appears again. It is likely that there is still
underlying residue that could not be removed.
Turn off : turn the tumble dryer off and then
on again.
Check for the possible causes described below.
The heat exchanger is clogged.
Check the heat exchanger. Follow the instructions
described in “Frequently Asked Questions –
Checking the heat exchanger”.
The plinth filter is clogged further down.
Check the plinth filter. Follow the instructions
described in “Frequently Asked Questions –
Replacing the plinth filter”.
If the plinth filter is not deformed or defective, you
can reactivate it in the washing machine. Follow
the instructions described in “Frequently Asked
Questions – Reactivating the plinth filter”.
The indicator light
comes on after a pro-
gram has been can-
celled and a signal
sounds.
The condensed water container is full or there is a
kink in the drain hose.
Empty out the condensed water container.
Check the drain hose.
See “Cleaning and care”.
To switch the indicator light off:
Open and close the door (with the dryer switched
on).
lights up. The program selector has been moved.
Select the original program. The time left will
appear on the display again.
Bars flash on the dis-
play at the end of a pro-
gram: .........
The program has finished but the laundry has not yet
cooled down.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
51
Loading ...
Loading ...
Loading ...