Loading ...
Loading ...
SET UP
INSTALLING THE CO
2
CYLINDER
SODASTREAM
®
CO
2
SCREW SYSTEM CYLINDER
1. Place the SodaStream
®
Fizzi One Touch
TM
Sparkling Water
Maker on a flat sturdy surface and remove the back cover.
2. Remove seal and cap from the SodaStream CO
2
Cylinder.
WARNING! Never insert or replace the CO
2
Cylinder while a
Carbonating Bottle is installed in the Sparkling Water
Maker. This can cause the Carbonating Bottle to be ejected
or burst. Tilt the Sparkling Water Maker forward and insert the
CO
2
Cylinder in the back of the Sparkling Water Maker.
Gently raise the CO
2
Cylinder and tighten by turning to the right
until it is firmly held in place. WARNING! Hand-tighten only.
DO NOT use tools; this can damage the Sparkling Water
Maker or CO
2
Cylinder. This may result in an uncontrolled
flow of CO
2
gas, causing the Carbonating Bottle to burst
and result in personal injury or property damage.
3. Connect the power cord to your Sparkling Water Maker. Run the
cord through the slots in the base. Insert the plug into the wall
outlet. The buttons will light up. Only use an original
SodaStream power adapter.
4. Reinstall the back cover. Now you are ready to create the
bubbles.
Please note that the
SodaStream
®
Fizzi
TM
is
compatible with the
SodaStream
®
CO
2
Screw
System Cylinder and is NOT
compatible with the
SodaStream
®
Quick Connect
Cylinder.
1
3
COMPATIBLE SODASTREAM
®
CO
2
SCREW SYSTEM CYLINDER
NON-COMPATIBLE
CO
2
QUICK CONNECT CYLINDER
Use Only SodaStream
CO
2
Screw System Cylinder
4
1
1
Flip
B
2
A
3
Loading ...
Loading ...
Loading ...