Loading ...
Loading ...
Loading ...
.l:h_[o]l:lgo]dll:{o]ll::Y__|ll]l_.-'_. ""
If you want to program functions not included in the basic
operations covered by the remote control code, or an
appropriate remote control code is not available, do the
following. You can program any of the buttons available
in the component control area (see page 75). The buttons
can be programmed independently for each component.
This remote control transmits infrared rays. If the other remote
control also uses infrared rays, this remote control can learn most
of its functions. However, you may not be able to program some
special signals or extremely long transmissions. (Refer to the
operating instructions for the remote control of your component.)
1 Press an input selector button to select a
source component.
Place this remote control about 5 to 10 cm
apart from the other remote control on a flat
surface so that their infrared transmitters are
aimed at each other.
DDD°
o
° °oo
BE}BO
0 000
5 to 10 cm (2 to 4in)
Press LEARN using a ballpoint pen or similar
object.
Do not press and hold LEARN. If you hold it down
for more than three seconds, the remote enters the
manufacturer code setting mode.
I : I;I I ,= _,;I
I_aL; FI IN
- !
Flashes alternately
Complete e:_ch of the following steps in 30 seconds.
Otherwise. the learning mode will be automatically
canceled. In this case. press LEARN again.
Press the button at which you want to
program the new function.
"LEARN" is displayed.
O!OlOs@!oi
00°0! ol o_
I °
[J[JI °
0 000
0 00°
@ @80
i=: ii; M J:=_ii_i
Press and hold the button you want to
program on the other remote control until
"OK" appears in the display window.
Ja- HO O O=B Bill, =
@ I-IIo=o;o, Di01Iiii =......N _i _1_ i
D is]o-o0oiq 41
i!i!iiiiii!!iU!_lii!i!iiiiii!i!i[!iiiii!!i,i!!
79
Loading ...
Loading ...
Loading ...