Loading ...
Loading ...
Loading ...
8°
Press guard onto support so that bottom of guard is
approximately 3/4 in. away from beFt°
NOTE: To remove guard, lift up on LONG TABS of
clips ... pull guard outward. The clips should remain
on the BELT GUARD SUPPORT.
8/4 IN.
i
ASSEMBLING HOLD-DOWN
(Included with Model 113.298240)
Locate the clamp assembly, support rod, two wing screws
and two washers in loose parts bag.
Screw the support rod (I) tightly into the hole in the miter
gauge head.
Position the clamp assembly (2) on the handle and rod...
install washers (3) and wing screws (4).
NOTE: The small knob (5) on the clamp screw must not
turn. Check nut underneath it ... it must be tight against
the knob. Use a 1/2 inch wrench to tighten it.
CLAMP LOCK
LATCH
1
PLUGGING IN MOTOR
1. From among the loose parts, find two wire ties
2. Route motor cord along right side of cabinet and snap
ties in 1/4" hole in side of cabinet. Secure two cords in
wire ties.
3. Plug motor cord into outlet on side of switch box.
19
Loading ...
Loading ...
Loading ...