Loading ...
Loading ...
Loading ...
8
OPERATION
Compressor
The compressor in your unit is designed to function silently. DO NOT plug in the unit immediately
after moving it or changing its position. Allow a minimum of 2 hours for the pressures inside the
refrigeration system to equalize and the oils in the compressor to settle. After plugging the unit in, let
it run for one more hour without load or product. The refrigerator may then be loaded.
NOTE: Do not touch the compressor top cover while the unit is running. It is designed for high
operational temperatures, and its surface can become very hot, which may cause burns.
(The compressor is located at the bottom of the refrigerator, behind the front louvers.)
Temperature Control
The temperature is controlled by a thermostat which is
located above the front ventilation louvers, just below the
door. The thermostat is factory-set to maintain the internal
temperature between 2 and 8°C (35.6 and 46.4°F). The
thermostat normally displays the temperature inside the
cabinet. The default setting is 2°C.
To change the set temperature,
1. Press and hold the set button for 5 seconds until “0” appears on the screen.
2. Release the button and press it again to confirm the “0” command.
3. Press the UP or DOWN buttons until you see the parameter “St” on the screen.
4. Press the set button again to enter that parameter.
5. With the UP and DOWN buttons choose the desired operating temperature. (NOTE: Only
temperatures from 2°C (35.6° F) to 8°C (46.4° F) are permitted.
6. Press set again to confirm the temperature.
7. Wait 1 minute without touching any button while the unit accepts the changes. It will then start
running normally.
Alarm Settings
● Your refrigerator is designed to sound an alarm if the internal temperature rises above15°C
(59° F) or falls below 0°C (32° F).
● To stop an alarm when it is sounding, press the SET/MUTE button on the thermostat.
Lighting
● LED lighting surrounds the glass on the interior side of the door. Additionally, the header panel
above the door is backlit.
● Cabinet lighting is designed to function continuously or may be controlled with a switch, located
inside the unit to the left of the internal fan in the ceiling. See Wiring Diagram, page 9. Putting
the refrigerator into Energy-Saving mode (see section above) will also turn off the interior
lighting.
Energy-Saving Mode
To save energy by limiting the length of operation time of the fan motors and compressor and by
turning off the interior light, you can put the refrigerator into Energy-Saving mode by pressing the
UP arrow (ECO) for 3 seconds. The display will show “ EnS“ when this mode is active. To
deactivate the Energy-Saving mode, press the UP arrow again and hold it for at least 3 seconds.
Loading ...
Loading ...
Loading ...