Loading ...
Loading ...
Loading ...
Required Tools
You will need the following tools:
Phillips T_
Head or
#2 Square Drive
Head
This Use & Care Guide provides general operating
instructions for your model. Use the unit only
as instructed in this Use & Care Guide. Before
starting the appliance, follow these important
first steps.
Location
• Choose a place that is near a grounded
electrical outlet. Do Not use an extension
cord or an adapter plug.
• If possible, place the unit out of direct
sunlight and away from the range,
dishwasher or other heat sources.
Install the appliance on a floor that is level
and strong enough to support the unit fully
loaded.
DO NOT install the appliance where the temperature will drop below 55°F (13°C) or rise above
110°F (43°C). The compressor will not be able to maintain proper temperatures inside the unit.
DO NOT block the kick plate on the lower front of your appliance. Sufficient air circulation is
essential for the proper operation of your unit.
The exterior walls of the appliance may become quite warm as the compressor works to transfer heat
O
from the inside. Temperatures as much as 30 F warmer than room temperature can be expected.
Installation 1,,(25ram)
Installation clearances:
Allow the following clearances for ease
of installation, proper air circulation, and
plumbing and electrical connections:
Sides - 3/8 inch
Top and Back - 1 inch
. Allow for trim kit if it is to be installed with
the unit.
If your unit is placed with the door hinge side
against a wall, you may have to allow additional
space so the door can be opened wider,
................ [
1"
__lm '-i) [ (10 mm)
Door Handle Hounting Instructions
1. Remove handle from carton and any other
protective packaging.
Loading ...
Loading ...
Loading ...