Loading ...
Loading ...
Loading ...
Installation Instructions
ROLLERS
The rollers have 3 purposes:
0 RolleI_ a(!just so the door closes easily when opened
about halfivav:
O Rollels a(!just so tile refl_igerator is firmly positioned
on the floor and does not wobble.
O Rollels allow )ou to inoxe tile reflJgerator axvay fl'oln
tile wall fin" cleaning.
To adjust the milers, remove the base grille by pulling it
out at tile bottom.
Turn the roller ac!jusfing screws dockwise to raise the
refl_igeratoi; comltercloclc_vise to lower it. Use an
a(!iustable wrench (3/8" hex head bolt) or pliers.
To replace base grille, line up the clips on back of grille
between tile bar and tile bottom _ff tile cabinet. Push
tin'ward until grille snaps into place.
DOOR ALIGNMENT
_MteI"leveling, inake sure that tile doolS are even at tile top.
To Inake file doolS even, a(!jttst file I'efiigeI_m n"door as t611_s:
O Relnove tile Base Grille, open tile dools, then pull tile
grille straight out.
Detemfine which otthe two doo_s is higher than the other:
O i,ifl tile lower dooi; along with tile slnall cam.
Place the shim between the Door Metal Hinge and the
small C_llI] _IS shown.
Press in tile shiln so that it fits in between tile inetal
hinge and tile plastic cam.
Close the dools and check if they are level at the top.
If one door is still lower than the othei; repeat the
process and insert another shiln.
_- uMerthefreshfood
doortophiogecover.
Shim
NOTE: If tile (loolS are not even and tile shim is alreadx
inserted, you can remoxe tile shiln to lower tile (looI:
INSTALLING THE WATER LINE
BEFORE YOU BEGIN
Tile water lille installation is not warranted bv tile
refl'igerator or icelnaker inanulhcturer. Follow these
recomlnendations carefllllv to ufinilnize tile risk of
exi)ensive water dalnage.
Water hammer (water banging in tile pipes) in house
pltmd)ing can cause damage to refrigerator parts and
lead to water leakage or flooding. Call a qualified
plumber to correct water hammer before installing
the water sui)ply line to the refrigerator,
To i)revent burns and I)roduct dalnage, do not hook
up tile water line to tile hot water line.
If wm use wmr refl'igerator before connecting the
water line, inake sure the icelnaker power switch is
in the O (off) position.
BEFORE YOU BEGIN (CONT.)
Do not install tile icelnaker tubing ill areas where
telnl)eratures tall below freezing.
When using any electrical device (such as a power
drill) dtuJng installation, be sure the device is
insulated or wired in a manner to prevent tile hazard
of electric shock.
All installations must be in accordance with local
plumbing code requirements.
Installation of the icemaker must be done by a
qualified service tech_ficim_.
a, WARNING!Coimect to potable
water sui)pl ) only.
15
Loading ...
Loading ...
Loading ...