Loading ...
Loading ...
Loading ...
TO INSTALL BATTERY PACK
See Figure 5.
NOTE: Battery pack is shipped in a lowcharge condition.
Therefore, it must be charged prior to use. Refer to page
12, "Charging Battery Pack" for charging instructions.
• Place battery pack in the saw.Align raised rib on
battery pack with groove inside saw, then slide battery
pack in saw as shown in figure 4.
• Make sure the latches on each side of the battery pack
snap into place and battery pack is secured in saw
before beginning operation.
LATCHES
BATrERYPACK
Fig. 5
,_ CAUTION: When placing battery pack in the saw,
be sure raisedrib on battery packaligns with groove
inside saw and latches snap into place properly.
Improper assembly can cause damage to saw and
battery pack.
TO REMOVE BLADE
See Figure 6.
• Remove battery pack from saw.
• Remove blade wrench from storage area.
• Position saw as shown in figure 6, depress spindle lock
button, and remove blade screw.
NOTE: Turn blade screw clockwise to remove.
• Remove outer blade washer.
NOTE: Blade can be removed at this point.
,_k WARNING: Battery tools are always in operating
condition. Therefore, switch should always be locked
when not in use or carrying at your side.
DEPRESSSPINDLE
LOCKBuI"rON
TO
LOOSEN
\
TO
TIGHTEN
BLADE GUARD SYSTEM
See Figure7.
BLADE
SCREW
BLADE
WRENCH
Fig. 6
The lower blade guard attached to the trim saw is there
for your protectionand safety. It should never be altered
for any reason. If it becomes damaged or begins to return
slow or sluggish, do not operate the saw until the damage
has been repaired or replaced. Always leave guard in
operating position when using saw.
,_ DANGER: When sawing throughworkpiece,lower
blade guard does not coverblade on the underside
ofworkpiece.Since blade isexposed on undersideof
workpiece,keephands and fingers away from cutting
area. Any part of your body coming incontactwith
moving blade willresultinserious injury.
Never use saw when guard is not operating correctly.
Guard should be checked for correct operation before each
use. if you drop the saw, check the lower blade guard and
bumper for damage at all depth settings before reuse.
NOTE: The guard is operating correctly when it moves
freely and readily returns to the closed position. If for any
reason the lower blade guard does not close freely, take
it to the nearestSears Service Center for service before
using.
LOWER BLADEGUARD
ISIN UP POSITION
WHENMAKINGA CUT
BLADEEXPOSEDON
UNDERSIDEOF WORKPIECE
13
Fig. 7
Loading ...
Loading ...
Loading ...