Loading ...
Loading ...
Loading ...
459922
Tools required: socket wrench No. 8, Phillips screwdriver, torx 25, fl at screwdriver
The procedure to change the direction of door opening should be carried out by at least two
persons.
1. Remove the upper hinge cover (A), the connector cover (B1) and the covering cap (M).
2. Disconnect the connector (C), undo the upper hinge (D) and remove the door (E) from the lower
hinge (I).
3. Remove the side panels (F) and (G), then unscrew and remove the middle panel (H).
4. Move the upper hinge (D) along with the connector and cable to the opposite side – make sure
to install the cable into the grooves in the panels like it was before disassembly. Then, replace
all three panels (F), (G), and (H).
5. Tilt the appliance backwards (make sure you do not press against the condenser unit on the
rear wall of the appliance as this may damage the cooling system), unscrew the lower hinge (I)
and the foot (J), and move them to the opposite side. Make sure the washer is installed like it
was before disassembly.
6. Move the cap (B2), door hinge (K) and retainer (L) to the opposite side and replace the door (E)
on the lower hinge (I).
7. Use the screws to attach the upper hinge (D) on the opposite side and reconnect the connector
(C).
8. Replace the upper hinge cover (A), the connector cover (B1) and the covering cap (M).
9. Replacing the handle (N): remove the handle covering caps, undo the screws, and remove
the handle. Remove the hole plugs on the opposite side of the door and attach the handle.
Replace the covering caps on the handle. Insert the new hole plugs supplied in the bag with the
instruction manual into the holes where the handle was initially attached.
11
Version II – Controls on
the door
Loading ...
Loading ...
Loading ...