Loading ...
Loading ...
Loading ...
TROUBLESHOOTING
f First try the solutions suggested here or visit our website at www.amana.comihelp for assistance
and to possibly avoid a service call.
Clothes are not drying
satisfactorily or drying
times are too long (cont.)
The load is too large and heavy
to dry quickly.
Separate the load to tumble freely.
Reduce load size to recommended load size in "Cycle Guide."
Fabric softener sheets are blocking The air outlet grille is just inside the door, behind the lint screen.
the grille. Check that it is not blocked by a fabric softener sheet.
Use only one fabric softener sheet, and use it only once.
The dryer is located in a room with Proper operation of dryer cycles requires temperatures above
temperature below 45°F (7°C). 45°F (7°C).
The dryer is located in a closet. Closet doors must have ventilation openings at the top
and bottom of the door. The front of the dryer requires
a minimum of 1" (25 mm) of airspace, and, for most
installations, the rear of the dryer requires 5" (127 mm).
See the Installation Instructions.
Cycle time is too short The load may not be contacting the Level the dryer. See the Installation Instructions. All four dryer
sensor strips on Automatic Cycles. feet should be in firm contact with the floor.
The automatic cycle is ending
early.
Change the dryness level setting on Automatic Cycles.
Increasing or decreasing the dryness level will change the
amount of drying time in a cycle. If loads are consistently
ending too early, see also "Changing the Automatic Cycle
settings to increase or decrease drying time."
Lint on load Lint screen is clogged with lint. Clean lint screen before each load.
Stains on load Improper use of fabric softener. Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can
stain your garments.
......Stains on drum Loose dyes in clothes. Drum stains are caused by dyes in clothing (usually blue
jeans). These will not transfer to other clothing.
Loads are wrinkled The load was not removed from Remove load promptly from dryer at the end of the cycle.
dryer at the end of the cycle. NOTE: Refer to garment care label instructions. Dry-clean-only
garments are not recommended.
The dryer was tightly packed. Dry smaller loads that can tumble freely. Results may also
_. vary depending on fabric type. .j
14
Loading ...
Loading ...
Loading ...