Loading ...
Make connections to water lines. Use
1/2" I.P.S. faucet connections (1) or
use coupling nuts (3) with 3/8"
O.D.ball-nose riser(2).Use
wrenches to tighten connections.
Do not overtighten.
Shut off water supplies. Place spout
through mounting hole in sink.
Secure spout with rubber washer (1),
metal washer (2) and nut (3).
WARNING: Please carefully read and properly follow the instructions for installation found in this manual.
1
STEPS:
3
2
1
Attach the hose to the connection
beneath the faucet by aligning the tabs
on quick connectors. Push quick
connectors housing firmly upward and
snap onto receiving tube tabs. Pull
down moderately to ensure connection
has been made.
If it is necessary to remove the quick
connectors, squeeze tabs on hose
between index finger and thumb, then
pull down to disconnect.
Important: After installation is
completed, remove aerator assembly.
Turn on hot and cold water supplies.
Turn handle to full open position for
one minute. Check for leaks.
Replace aerator.
3
2
Place handle assembly through side
hole in sink. Secure handle assembly
with washer (1) and nut (2). Make
sure that the slot on nut is facing up.
Make sure handle is facing forward
and it swings equally in both
directions.
2
1
2-Ø1 3/8" (Ø35mm)
Loading ...
Loading ...