Loading ...
Loading ...
Loading ...
17
Ridged
Side
INSTALLATION
WIRING
6
Electric Shock Hazard
Electric Shock Hazard.
To prevent serious injury or death:
• BEFORE installing or servicing your fan, ALWAYS disconnect the power by turning off the circuit
breaker or breakers to the fan locations and conrm Lockout/Tagout procedures are in place.
• If you cannot lock the circuit breakers in the off position, securely fasten a prominent warning
device, such as a tag, to the electrical panel.
• All wiring must be in accordance with national and local electrical codes, including ANSI/NFPA
70. If you are unfamiliar with wiring or in doubt, consult a qualied electrician.
K
N
N
L
L
A
B
B
Fully unscrew power connector. Place power cable and canopy ground wire through power connector
end. Next, slide male power connector housing over wires. Using a small phillips head screw driver,
back off screws on one half of wire terminal. The ridged side of the power cable is the neutral and goes
into the hole marked (N). The center wire from the power cable is ground. Twist together with ground
wire from canopy and insert into hole with ground symbol (
). The outer wire without ridges is the
Live (L) and goes into the hole marked (L). Tighten down all terminal screws securely to make wire
connections. Repeat for wires from ceiling with female power connector housing and the other power
connector end. To secure the power connector, tighten male to female and then the connector ends by
twisting clockwise. (all sections of the power connector)
A
Fully unscrew data connector and remove the gasket from either
end. Slide data connector end over data cable. Slip gasket onto
data cable text side out and insert gasket into data connector end.
Push gasket until it is ush with data connector end. Slip data
connector housing over data cable. Plug data cable into center
connector and thread data connector housing onto data connector
center by twisting clockwise until tight. Thread data connector end
onto data connector housing by twisting clockwise until tight and
gasket seals the cable. Repeat for the other end.
K1
K2
Data Connector
End
Power Connector
End
Downrod Wiring Ceiling Wiring
Canopy
Ground Wire
Power Connector
End
Data Connector
End
Data Connector
Housing
Male Power
Connector Housing
Female Power
Connector Housing
Data Connector
Housing
Data Connector
Center
Power
Connector Center
Data Cable
Data Cable Sealed
Gasket
Gasket
Power Cable Sealed
Power Connector
Center Wiring Engaged
Loading ...
Loading ...
Loading ...