Loading ...
Loading ...
Loading ...
Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
pressurewasher, please call the pressurewasher helpline
at 1-800-222-3136.
UNPACKTHE PRESSUREWASHER
1. Remove everything from carton except pressurewasher.
2. Opencarton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTONCONTENTS
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
• Main Unit
• Handle
• Accessory Tray
• High PressureHose
• Spray Gun
• Spray Tip Extension with Quick Connect Fitting
• Oil Bottle
• HoseWrap
• DetergentSiphoning Hose/Filter
• Bottle Bracket Wireform
• PerfectMixTM Siphoning Unit/Hose
• Parts Bag(which includes the following):
• Operator's Manual
• Owner's Registration Card
• Bag containing 4 multi-colored Spray Tips
• HandleFasteningHardwareKit (which includes):
• Handle Bolts (2)
• Carriage Bolt (1)
• Plastic Knobs for Handle (2)
• Rope Guide(1)
• Plastic Knob (2)
• Tree Clips (4)
Becomefamiliar with each piece before assembling the
pressure washer Identify all contents with the illustration on
page 6 If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLINGPRESSUREWASHER
Your Craftsman pressure washer will need assembly before
operation:
1 Fill out and send in registration card
2 Attach handle and accessory tray
3 Connect detergent siphon hose to pump
4 Add oil to engine crankcase
5 Add fuel to fuel tank
6 Connect pressure hose to spray gun and pump
7 Connectwater supply to pump
8 Attach spray tip extension to spray gun
9 Select/attach quick connect spray tip to spray tip
extension
Attach Handle and Accessory Tray
1 Place handle(A) onto handle supports (B) connected to
main unit Make sure holes (6) in handlealign with holes
(6) on handle supports
,
,
,
Insert handle carriage bolts (D) through holes from
inside of unit and attach a plastic knob (E) from outside
of unit Tighten by hand By loosening both knobs to the
middle section of the attachment bolt, the upper handle
can fold forward to store flat atop the cold engine Note:
DO NOTfold the handle down while the engine is hot
Placeaccessory tray (F) over holes (6) on handle
(viewing from back of unit) Push the tree clips (H) into
the holes until they sit flat against the accessory tray
/
Insert multi-colored Quick Connect spray tips and other
supplied accessories in spaces provided in accessory
tray SeeHow to Use Accessory Tray
Loading ...
Loading ...
Loading ...