Loading ...
Loading ...
Loading ...
6vax.com.au
Looking After Your Machine – Filters
Emptying and cleaning the dirt container
Remove dirt container
by pushing down the dirt
container release button and
lifting the dirt container.
Remove dirt container Remove dirt container
Hold the dirt container over a bin and press the dirt release latch
(located at the rear of the dirt container).
Hold the dirt container over a bin and press the dirt release latch Hold the dirt container over a bin and press the dirt release latch
Tap excess dirt from the lter. Rinse under a tap and leave to dry for 24 hours.
1
2
3
Hold the dirt container and
twist the lid anti-clockwise.
Lift the lid to reveal the
pre-motor lter.
Lift out the pre-motor lter.
TAP
4
MAX
40˚C
5
24hr
6
Cleaning the pre-motor lter
IMPORTANT: If the air inlet, hose or telescopic tube is blocked, switch o the vacuum cleaner and remove the
blockage(s) before re-starting the vacuum cleaner.
IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason the unit should overheat, the thermostat
will automatically turn the unit o . Should this occur, unplug the vacuum cleaner from the electrical socket and turn o
the switch. Remove and empty the dirt container. Check the hose for blockages. Clean the lters. Allow the unit to cool
for approximately one hour (if you have cleaned the lters you will need to wait twenty four hours for the lters to dry
before putting them back in the machine). To re-start the machine, plug it into an electrical socket and switch it back on.
IMPORTANT: Water
temperature should
not exceed 40°C when
washing pre-motor lter.
IMPORTANT: Ensure
lters are completely dry
before inserting back into
the vacuum cleaner.
Loading ...
Loading ...
Loading ...