Loading ...
Loading ...
Loading ...
AttachaWheel(66)tothebaseoftheUprights(69)with
aWheelBolt(64)andaNut(13)asshown.Donot
overtightentheBolt;theWheelshouldturnfreely.
Withthehelpofasecondperson,carefullytipthetread-
millontoitsotherside.Seeassemblystep1,andattach
theotherExtensionLeg(63)andtheremainingtwo
BasePads(57).Then,attachtheotherWheel(66)as
describedabove.
Withthehelpofasecondperson,carefullylowerthe
baseoftheUprights(69)tothefloorsotheUprightsare
inaverticalposition.
69
64
66
If there is a board between the Uprights (69), remove the
board and the two bolts. Discard the board and the bolts.
Identify the Right Handrail (72), which has a large hole in
the left side. Remove the wire tie securing the Upright
Wire (42) inside of the right Upright (69). Feed the
Upright Wire into the hole in the bottom of the Right
Handrail and out of the large hole in the side. Note: It
may be helpful to use needlenose pliers to pull the Wire
Harness out of the hole.
Set the Right Handrail (72) on the right Upright (69).
Attach the Right Handrail with two Handrail Bolts (37)
and two Handrail Star Washers (95). Be careful not to
pinch the Upright Wire (42).
Attach the Left Handrail (71) as described above. Note:
There is not an upright wire on the left side.
3
37
69
95
72
\
95
Hold the Console Base (47) near the Left Handrail (71).
Attach the end of the ground wire on the Console Base
to the indicated small hole in the Left Handrail with the
Silver Ground Screw (75).
Small
71
47
Ground
Wire
...._ 75
Loading ...
Loading ...
Loading ...