Loading ...
Loading ...
Loading ...
Pipe Tower Mount Version using the TC3-S
Step 1: Attach Male Connector (10) from clamp base to Female Connector (11)
Step 2: Push connector into center hole of speaker as you place clamp base
onto the speaker housing. Insert 4 bare wires down into this hole as well. These
wires are only used if you are adding the LED speaker rings. (please see LED
speaker install instructions for LED install) Please make sure the grommet (12)
is seated properly.
Step 3: Attach two LONG Allen Bolts (4) through the clamp base and tighten
into the housing. Please make sure these are tight. It is also recommend to use
a Blue Loctite on these bolts.
NOTE: ALLEN BOLTS TO ATTACH CLAMPS WILL BE INCLUDED IN
THE MAIN REV 410 PACKAGING, NOT INSIDE THE CLAMP BOX.
THERE WILL BE EXTRA BOLTS NOT USED.
Step 4: Clamp Bottom (3) and Detachment Plate (5) are already connected
together. Insert the detachment plate into the clamp base (9). Please make sure
the male speaker plug (7) and female speaker plug (4) are lined up properly.
The male speaker plug (7) inside the clamp base can rotate. Please rotate this
so that it is facing the proper direction. There is a U shaped groove on the
female that lines up with a boss on the male.
Step 5: Slide the detachment fork (17) into the grooves on the clamp base.
Attach the allen locking bolt (19) and tighten down.
Step 6: Find the mounting location for the speaker and clamp and then mark the
location on the bottom side of the pipe for the speaker wire. The speaker wire
will be inserted back into the pipe for a clean installation.
Step 5 You will DRILL a hole in the bottom center of the pipe. You should
also de burr the hole and add a rubber or plastic grommet so the wire is not
damaged by touching bare metal. This can cause your speakers to short out and
damage your speakers and amplifiers. The speaker wire will be inserted back
into the pipe for a clean installation.
Loading ...
Loading ...
Loading ...