Loading ...
Loading ...
Loading ...
ACAUTION: Before performing any
service or adjustments:
1, Release control bar and stop engine.
2. Make sure the blade and all moving
parts have completely stopped.
3. Disconnect spark plug wire from spark
plug and place where it cannot come
in contact with plug.
LAWN MOWER
TO ADJUST cUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in
the Operation section ofthis manual.
REAR DEFLECTOR
The rear deflector, attached between the
rear wheels of your mower, is provided to
minimize the possibilitythat objects will
be thrownout of the rear of the mower
intothe operator's mowing position. If the
deflectorbecomes damaged, it should be
replaced.
TO ADJUST HANDLE
The handle on your lawn mower has
three (3) height positions- adjust to
heightthat suits you.
Squeeze the bottom ends of lower
handle towards each other until the pin
in handle can be inserted into one of
the three height adjustment holes.
High,
3-position
handle
TO ASSEMBLE GRASS CATCHER
1.Put grass catcher frame intograss bag
with dgid part of bag on the bottom.
Make sure the fTame handle is outside
of the beg top.
2.Slip vinyl bindings over frame.
NOTE: Ifvinyl bindingsare too stiff,hold
them in warm water fora few minutes. If
bag gets wet, let it dry before using.
ACAUTION: Do not runyour lawn
mower without clippingdeflector or
approved grass catcher in place. Never
attempt to operate the lawn mowerwith
the rear door removed or propped open.
Catcher _
frame r _-"_
hand__
"_ _--'_ Frame
I _ opening
ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or itmay result in personal injury.If you
believe that the engine is running too fast
or too slow,take your lawn mowerto a
Sears or other qualified service center for
repair and adjustment.
CARBURETOR
Your carburetor has a non-adjustable
fixed main jet for mixturecontrol. If your
engine does not operate propedy due to
suspected carburetor problems, take your
lawn mower to a Sears or other qualified
service center for repair and/or adjust-
ment.
IMPORTANT: Never tamper with the
engine governor,which is factory set for
proper engine speed. Overspeeding the
engine above the factory high speed
setting can be dangerous. If you thinkthe
engine-governed high speed needs
adjusting, contact a Sears or other
qualified service center, which has proper
equipment and expedence to make any.
necessary adjustments.
14
Loading ...
Loading ...
Loading ...