Loading ...
Loading ...
Loading ...
5
Before you begin, thoroughly familiarize yourself with the control panel and remote
as shown below and all its functions, then follow the symbol for the functions you
desire. The unit can be controlled by the touch pad alone or with the remote.
ELECTRONIC CONTROL
Air Conditioner Features
.devreser sthgir llA.cnI ,stcudorP emoH xulortcelE 9002
REMOTE CONTROL
Air Conditioner Features & Operating Instructions
Operating Instructions
N
O
TE
The following instructions represent the Touch Pad, the same instructions can be used for the Remote Control.
:EES LLIW UOY:NO TINU NRUT OT
PRESS ON/OFF BUTTON
DO THIS:
UNIT CONTROL
ADJUSTS
TEMPERATURE
OR TIME
DISPLAYS TEMPERATURE/TIME
SETS FAN
SPEED
SETS MODE
TURNS UNIT
ON OR OFF
ACTIVATES
TIMER
CHECK FILTER
RESET BUTTON
SLEEP MODE
NOTE: The unit will run in energy saver(econ) mode
when powered on each time, if last shutdown is in cool
or energy saver(econ) mode.
In this mode, the fan will
continue to run for 3 minutes after the compressor shuts off.
The fan then cycles on for 90 seconds at 10 minute intervals
until the room temperature is above the set temperature, at
which time the compressor turns back on.
This product contains a lithium button/coin cell
battery. If a new or used lithium button/coin
cell battery is swallowed or enters the body, it
can cause severe internal burns and can lead
to death in as little as 2 hours. Always
completely secure the battery compartment.
If the battery compartment does not close
securely, stop using the product, remove the
batteries, and keep it away from
children. If
you think batteries might have been swallowed
or placed inside any part of the body, seek
immediate medical attention.
The cells shall be disposed of properly,
including keeping them away from children;
Even used cells may cause injury.
WARNING: Chemical Burn Hazard.
Keep batteries away from children.
Battery Size: CR2025
TO REPLACE BATTERY
TAB
Turn Remote Control upside down.
Squeeze tab and pull to remove
battery tray. Place battery in tray with
POSITIVE(“+”) side facing UP,
according to diagram. Re-insert battery
tray.
Loading ...
Loading ...
Loading ...