Loading ...
Loading ...
Loading ...
11
The control uses only the 15% of the available
power, divided in 0 to 9 steps with a better
accuracy.
Keep in mind that power level 9 in this special
mode correspond exactly to level 4 in the
standard range.
Select the zone and touch the [LOW TEMP] key
again in order to disable the Low Power Scale and
restore the standard one, without switching off the
zone.
Pay attention: the level remains the same but
the power increases.
Switching off a cooking zone as described below
disables the Low Power mode. When the zone will
be selected again it will start to work in the
standard power mode.
Switching an element off
Touch the related [OFF] key (ref.1) in order to
stop a heating element.
You may turn off all active elements at the same
time by touching the main [ON/OFF] key.
Hot surface indicator light
Each element has a HOT SURFACE indicator
light (ref.3) to show when the cooking area is hot.
This indication turns on when the zone is
activated and remains ON until the cooking area
has cooled down to a “safe to touch” temperature
(approximately 150°F).
If a hot surface light is ON use caution when
working around the cooktop as it is still hot.
Fast Boil (Booster) function
Once a heating element has been selected, touch
the [FAST BOIL] key to enable/disable this
function, before or after setting the power level.
A beep sounds and the heater display shows the
selected power level and a “P” alternatively. The
“Peacock Tail” shows the selected power level.
The heater works using some extra power
available only for some minutes then it gets back
to the selected power level.
This option is available for all the cooking zones,
both standard, both special ones (multiple zones).
Key Lock function
The key lock function is activated or deactivated
holding the [LOCK] key for 2 seconds. The lock
indication turns on, the keyboard is locked. Of
course, the [LOCK] key itself is always enabled.
The keys are automatically locked at start-up.
The locking function can be activated regardless
of the heaters condition (working or not). The key
lock function locks all the keys but the [OFF] ones.
Also the general [ON/OFF] key remains active for
the off function.
Setting the timer
It works as a minute minder and it doe sn’t
stop any heating element.
The timer is available in some models only. It can
be set independently from the heating element,
even if there aren’t any working zones. If the
cooktop is not working, touch first the main
[ON/OFF] key to enter stand-by mode, with all
displays showing “0”.
Figure 9.
Touch [T-] or [T+] keys to set the timer: the initial
value starts from “00” or “45” respectively on the
timer display (ref.1). Hold the key in order to
fasten the increase/ decrease speed. The
maximum value is “99”.
The timer led (ref.2) indicates whether the timer is
running.
The dot in the lower right corner of the display
(ref.3) is flashing when the timer has been
selected in order to change its value. After 5
seconds since the last touch the new value is
accepted and the dot disappears.
Loading ...
Loading ...
Loading ...