Loading ...
Loading ...
Loading ...
o
Power automatically turns off
0
This unit is linked to the power of the source device connected to the HDMI input connector, and automatically turns to standby.
o
Operations cannot be performed through the remote control unit
0
The battery is used up. Replace it with a new battery (CR2032).
0
Operate the remote control unit within a distance of about 23 ft/7 m from this unit and at an angle of within 30°.
0
Remove any obstacle between this unit and the remote control unit.
0
The orientation of the coin type lithium battery (CR2032) is incorrect. Confirm that the q mark on the battery is facing upward.
0
The set’s remote control sensor is exposed to strong light (direct sunlight, inverter type fluorescent bulb light, etc.). Move the set to a place in which the
remote control sensor will not be exposed to strong light.
0
This will disable remote sensor reception of this unit.
o
No video is shown on the TV
0
Check the connections for all devices.
0
Insert connection cables all the way in.
0
Check whether you have mistaken the HDMI input connector for the HDMI output connector or vice versa.
0
Confirm that the power of the source device is turned on.
0
Confirm that the correct inputs are selected for this unit, the AV receiver/AV amplifier, and the TV.
0
Confirm that the resolutions of the source device and the TV are correct.
0
When enjoying content that is copyright-protected with HDCP 2.2 or HDCP 2.3, use a source device and TV that are compatible with HDCP 2.2 or
HDCP 2.3.
0
Use a certified Ultra High Speed HDMI cable to enjoy 8K or 4K 120Hz videos.
Contents
Connections Operations Troubleshooting Appendix Specifications
21
Front panel Rear panel Side panel Remote
Loading ...
Loading ...
Loading ...