Loading ...
Loading ...
Loading ...
This Owner's Guide provides specific operating instructions
for your model.. Use the freezer only as instructed in this
Owner's Guide Before starting the freezer, follow these
important first steps,
INSTALLATION
• Choose a place that is near a grounded electrical outlet
Do Not use an extension cord or an adapter plug
• For the most efficient operation, the freezer should be
located where surrounding temperatures will not exceed
110°F (43°C). Temperatures of 32°F (0°C) and below will
NOT affect freezer operation. Additional compressor
heaters are not recommended
• Allow space around the unit for good air circulation
Leave a 3 inch (75 mm) space on al] sides of the freezer
for adequate circulation.
3" (75 ram)
3_(75mm)
Installation
NOTE: The exterior walls of the freezer may become quite
warm as the compressor works to transfer heat from the
inside. Temperatures as much as 30° F warmer than room
temperature can be expected. For this reason it is particu-
larly important in hotter climates to allow enough space for
air circulation around your freezer
LEVELING
The freezer must have alI bottom corners resting firmly on
a solid floor The floor must be strong enougil to support a
fully loaded freezer NOTE: It isVERY IMPORTANT for
your freezer to be level in order to function properly. If the
freezer is not leveled during installation, the door' may be
misaligned and not close or seal properly, causing cooling,
frost, or moisture problems
To Level Upright Models:
After discarding crating screws and wood base, use a
carpenter's level to level the freezer from front-to-back
Adjust the plastic leveling feet in front, !/2bubble higher, so
that the door closes easily when left halfway open
To Level Chest Models:
/f needed, add metal or wood shims between foot pads and
floor
CLEANING
Wash any removable parts, the freezer interior, and
exterior with mild detergent and warm water Wipe dry
DO NOT USE HARSH CLEANERS ON THESE
SURFACES,
Do not use razor blades or other sharp instruments,
which can scratch the appfiance surface when removing
adhesive labels Any glue left from the tape can be
removed with a mixture of warm water and mild deter-
gent, or touch the residue with the sticky side of tape
already removed,DO NOT REMOVETHE SERIAL PLATE.
_To allow door to
close and seal properly, DO NOT let
food packages extend past the front
of shelves
Shelf Front
Loading ...
Loading ...
Loading ...