Wet Sounds REV 410 B-SCSS V2 User Manual

Loading ...

Step 6: Slide the wire jacket (13) down the wire and Butt Connect the speaker

wire coming from the tower to the speaker wire plug (4). Red is positive and

black is negative. If you have added the LED accessory, this speaker wire plug

(4) will have 6 conductors. Please refer to the LED install instructions.

Step 7: Attach Clamp Top (2) to clamp bottom (3) using the two Allen Bolts (2)

There are various length bolts included. There is 3 sizes. Small 30 mm length

that fits 1 ¾ to 2 ¼ inch sized pipe, medium 45 mm length that fits 2 ¼ to 2 ½

inch sized pipe and long 60 mm length that fits 2 ½ to 3 inch sized pipe.

Step 8: Make sure the clamp is tightened all the way so there is no movement

Step 9: The swivel clamp allows you to rotate the clamp slightly on the dual

clamp set up of the REV 410 to work on towers with slight curves. Then tighten

the bolt to lock it in place.

Step 10: The swivel clamp also allows you to remove the speaker from the

tower in seconds. Loosen the allen locking bolt (19) and remove the

detachment fork (17). Once removed, the speaker will disconnect from the

clamp. The clamp remains on the tower. To reinstall, line up the male speaker

plug (7) so that it is centered and insert the speaker by plugging the connector

together and reinstalling the detachment fork.

Loading ...

Wet Sounds REV 410 B-SCSS V2 Revolution Series Dual 10" Black Marine Tower Speaker (Each) REV410BSCV2