Loading ...
Loading ...
Loading ...
OPERATION
PREPARING THE PRESSURE WASHER
1. Place the pressure washer on a secure, stable surface to prevent it from tipping during operation.
2. Check that all connections have been properly installed and secured.
• The high pressure hose is properly fastened to the gun hose connector.
• The spray lance is properly attached to the spray gun.
• The garden hose is properly fastened to the pressure washer’s water inlet adapter.
CAUTION: This unit is intended to be used with cold water only. Do not use hot water in this pressure washer.
3. Turn on the water supply on.
4. Release the trigger safety lock and pull the trigger for a few seconds until water flow is steady. This will allow
air to escape and discharge any pre-existing pressure from the gun and the hose. Then turn off the water.
5. Select Nozzle
6. a. Push the ring at the other end of the metal lance away
b. Put the nozzle in and press hard to make sure it's completely
stuffed in
c. Release the rings on the metal lance
OPERATING THE PRESSURE WASHER
1. Make sure the ON / OFF switch is in the OFF position. Plug the Ground Fault Circuit Interrupter (GFCI) into a
matching receptacle (see page 8 for important electrical information). We recommend that you test the GFCI as part of
your startup procedure each time you use your pressure washer as instructed below.
Press the RESET button (Fig. 10 - 1), and the power indication light should turn on. Press the TEST button (Fig. 10 -
2), and the power indication light should turn off. Do not use if the test fails. Press the RESET button again after
completing the test to enable operation.
12
Fig.7
Fig.9
Fig.8
Loading ...
Loading ...
Loading ...