Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR INSTRUMENT PANEL 105
Odometer (Premium Instrument Cluster)
Show
Hide (Odometer will still appear when door is open)
Defaults
Restore
Cancel
Defaults
Restore
Cancel
Speed Warning — If Equipped
Push and release the
up
or
down
arrow button until
Speed Warning is highlighted in the instrument cluster
display. Push and release the
OK
button to enter Speed
Warning. Use the
up
or
down
arrow button to turn
the Speed Warning ON or OFF, then push and release the
OK
button to confirm the selection. If the ON status is
selected, use the
up
or
down
arrow button to set the
desired speed, then push the
OK
button to set the speed for
the Speed Warning. A Speed Warning light will illuminate in
the instrument cluster, with a number matching the set
speed, with a pop-up message to inform the driver that the
Speed Warning has been set to the desired speed. Each
time the set speed is exceeded, a single chime will sound
and a pop-up warning message will display.
If the set speed is exceeded more than 2 mph (3 km/h), a
continuous chime will sound for up to 10 seconds, or until
the speed is no longer exceeded. The telltale in the
instrument cluster will also change from white to yellow,
and a pop-up warning message will pop-up on the
instrument cluster display.
NOTE:
Speed Warning is unavailable while KeySense is in use.
BATTERY SAVER ON/BATTERY SAVER
M
ODE MESSAGE — ELECTRICAL LOAD
R
EDUCTION ACTIONS — IF EQUIPPED
This vehicle is equipped with an Intelligent Battery Sensor
(IBS) to perform additional monitoring of the electrical
system and status of the vehicle battery.
In cases when the IBS detects charging system failure, or
the 12 Volt vehicle battery conditions are deteriorating,
electrical load reduction actions will take place to extend
the driving time and distance of the vehicle. This is done
by reducing power to or turning off non-essential 12 Volt
electrical loads. Load reduction will be functional when
the vehicle propulsion system is active.
The vehicle may not be running depending on the High
Voltage (HV) battery State Of Charge (SOC) or
temperature. It will display a message if there is a risk of
battery depletion to the point where the vehicle may stall
due to lack of electrical supply, or will not restart after the
current drive cycle.
When 12 Volt load reduction is activated, the message
“Battery Saver On” or “Battery Saver Mode” will appear in
the instrument cluster display.
Base Instrument Cluster Display Screen Setup Options:
Upper Left
None Compass Outside Temp
Time Range
Average
(MPG, L/100km,
or km/L)
Current
(MPG, L/100km,
or km/L)
Trip B Distance Trip A Distance
Base Instrument Cluster Display Screen Setup Options:
Upper Right
None Compass Outside Temp
Time Range
Average
(MPG, L/100km,
or km/L)
Current
(MPG, L/100km,
or km/L)
Trip B Distance Trip A Distance
Base Instrument Cluster Display Screen Setup Options:
Center
None Compass Outside Temp
Time Range
Average
(MPG, L/100km,
or km/L)
Current
(MPG, L/100km,
or km/L)
Trip A Distance Trip B Distance
Audio Menu Title Menu Title Digital Speed
3
22_RUP_OM_EN_USC_t.book Page 105
Loading ...
Loading ...
Loading ...