Loading ...
Loading ...
Loading ...
14
www.napoleon.com
N415-0705-AU SEP 30.20
The burner is made from heavy wall 304 stainless steel, but extreme heat and a corrosive
environment can cause surface corrosion to occur. This can be removed with a brass wire brush.
CAUTION!
Spiders and insects are aracted to the smell of Universal Liqueed Petroleum Gas (ULPG). The burner is
equipped with an insect screen on the air shuer, which reduces the likelihood of insects building nests
inside the burner but does not enrely eliminate the problem. A nest or web can cause the burner to burn
with a so yellow or orange ame or cause a re (ashback) at the air shuer underneath the control
panel. To clean the inside of the burner, it must be removed from the gas grill: Remove the screw (s)
that aaches the burner to the back wall. Slide the burner back and up wards to remove. Cleaning: Use
a exible venturi tube brush to clean the inside of the burner. Shake any loose debris from the burner
through the gas inlet. Check the burner ports and valve orices for blockages. Burner ports can close over
me due to cooking debris and corrosion, use an opened paperclip or the supplied port maintenance bit
to clean them. Drill out blocked ports using this drill bit in a small cordless drill. The ports are easier to
clean if the burner is removed from the grill, but it can also be done with the burner installed. Do not ex
the drill bit when drilling the ports, as this will cause the drill bit to break. This drill is for burner ports only,
not for the brass orices (jets) which regulate the ow into the burner. Take care not to enlarge the holes.
Ensure the insect screen is clean, ght, and free of any lint or other debris.
Reverse the procedure to reinstall the burner. Check that the valve enters the burner when
installing. Replace sear plate mount and / or ghten screws to complete reinstallaon.
WARNING!
CAUTION!
: Clean casngs periodically with warm soapy water. Aluminum will not rust, but high
temperatures and weathering can cause oxidaon to occur on aluminum surfaces. This appears as white
spots on the casngs. To renish these areas, clean rst and sand lightly with ne sandpaper. Wipe the
surface to
remove any residue and paint with high temperature barbecue paint. Protect surrounding
areas from over-spray. Follow the manufacture’s direcons for curing.
!
!
Problem Possible Causes Soluon
Low heat / Low ame
when valve turned to high.
Improper lighng procedure.
Improper preheang.
Ensure lighng procedure is followed
carefully.
All gas grill valves must be in the o
posion when the tank valve is turned on.
Turn tank on slowly to allow pressure to
equalize. See lighng instrucons.
Pipe must be sized according to installaon
code.
Preheat grill with main burners on high for
10 minutes.
Loading ...
Loading ...
Loading ...