Loading ...
Loading ...
Loading ...
USER REPLACEABLE SERVICE PARTS
REPLACEMENT PART
Container of Replacement Line
Assist Handle
Bolt Carriage, 1/4-20
Wing Nut
Shield Assembly
Edge Guide
'_ WARNING: Perform the following
PART NUMBER
71-85907
530403805
530403886
530016152
530404393
530403845
steps after each use.
• Stopthe unit and disconnect the pow-
er source when not in use.
• Carry the unit with motor stopped.
• Store the unit so the line limiter blade
cannot cause injury.
• Store unit and extension cord indoors
in a high, dry place out of the reach of
children. Store unit unplugged.
• Store unit with all guards in place.
Position unit so that any sharp object
cannot accidentally cause injury.
TROUBLESHOOTING TABLE
WARNING: Always stop unit and disconnect from tile power source before
performing all of the recommended remedies below except remedies that re-
quire unit to be operating.
TROUBLE CAUSE REMEDY
Trh-nmer head 1. Crowdh_g line against 1. Allow tip of Ih_eto do the cutth_g.
stops under a material being cut.
load or does not 2. Electrical failure. 2. Contact Sears Service (see back
turn when switch cover).
is pressed. 3. Thrown circuit breaker. 3. Check breaker box.
4. Debris stopping head. 4. Remove debris.
Line breaks 1. Line improperly routed 1. Check line routing.
while cutting, in head.
2. Incorrect line size 2. Use only 0.080 inch (2 mm) dia. line.
3. Dirt build-up on unit. 3. Clean unit.
Line welds onto 1. Line size is incorrect. 1. Use only 0.080 inch (2 ram) dia. line.
cutting head. 2. Crowding line against 2. Allow tip of line to do the cutting.
material being cut.
Line usage is 1. Line improperly routed 1. Check line routing.
excessive, in head.
2. Line size is incorrect. 2. Use only 0.080 inch (2 mm) dia. line.
3. Crowding line against 3. Allow tip of line to do the cutting.
material being cut.
4. Cutting head worn or 4. Contact Sears Service (see back
damaged, cover).
lO
Loading ...
Loading ...
Loading ...