Loading ...
Loading ...
Loading ...
_.'_o_ V:__Imy:_m_ll_,_l i _vAI_ _i i
HOW TO ADJUST OR REPLACE
THE FRICTION WHEEL
How To Check The Friction Wheel
Ifthe snow thrower will not move for-
ward, check the traction drive belt, the
traction drive cable or the friction wheel.
Ifthe friction wheel is worn or damaged,
it must be replaced. See "How To Re-
place the Friction Wheel" in this section.
Ifthe friction wheel is not worn or dam-
aged, check as follows.
1. Run the engine until the fuel tank is
empty and the engine stops.
2. Stand the snow thrower up on the
front end of the auger housing
(see Figure 28).
3, Disconnect the spark plug wire,
4, Loosen the bolts on each side of
the bottom panel (see Figure 28).
5. Remove the bottom panel.
6. Position the shift speed lever in
the lowest forward speed.
7. Note the position of the friction
wheel (see Figure 29). The correct
distance "A" from the right side of
the friction wheel to the outside of
the motorbox is as follows:
Tire Size Distance "A"
12 and 13 inch 4-1/8"
16 inch 4-5/16"
If the friction wheel is not in the
correct position, adjust according to
the following instructions.
How To Adjust The Friction Wheel
1. Position the shift speed lever in
the lowest forward speed.
2. Loosen the bolts on the speed
control rod (see Figure 30).
3. Move the friction wheel to the cor-
rect position (see Figure 29).
4. Tighten the bolts on the speed
control red (see Figure 30).
F-031098L
5. Install the bottom panel (see
Figure 28).
6. Tighten the bolts on each side of
the bottom panel.
Bolt Bottom Panel
Auger
Housing
Bolt
'\'\
Figure 28
Figure 29
Speed Control Rod
_Boits
_7
25
Figure 30
Loading ...
Loading ...
Loading ...