Loading ...
Loading ...
Loading ...
TROUBLESHOOTING CHART
PROBLEM CORRECTION
Excessive
vibration
Starter rope hard
to pull
CAUSE
1. Worn, bent or loose blade.
2. Bent engine crankshaft.
1. Engine flywheel brake is on
when control bar is released.
2. Bent engine crankshaft.
Loss of drive
Grass catcher
not filling (if so
equipped)
Hard to push
3. Blade adapter broken.
4, Blade dragging in gross.
I• Drive wheels not turning
with drive control engaged..
2. Belt not driving
!. Cutting height too !ow,
2. Lift on blade worn off.
3. Catcher not venting air,
1. Grass is too high or wheel
height istoo low.
2. Rear of lawn mower
housing or blade dragging
in grass.
3. Grass catcher too full.
4. Handle height position not
right for you.
1. Replace blade. 1]ghten
blade bolt.
2. Contact an authorized
service center.
1. Depress control bar to
upper handle before
pulling starter rope.
• 2. Conta_ an authorized
service center.
3. R_p_ace blade adapter.
4, t,Aove lawn mower to cut
grass or to hard surface•
i. Adjust or replace drive control
cable.
2. Put belt on pulleys or
[epiace belts if broken.
i, Raise cutting height,
2. Replace blade.
3, Clean grass catcher,
1. Raise cutting height.
2. Raise rear of lawn mower
housing one (1) setting
higher.
3. Empty grass catcher.
4. Adjust handle height to
suit.
18
Loading ...
Loading ...
Loading ...