Loading ...
Loading ...
Loading ...
13
CO
2
Regulator and CO
2
Cylinder
NOTE: Your CO
2
cylinder is shipped empty to avoid any possible accidents during
transportation. When you purchase the first keg of beer, have your beer distributor fill
the CO
2
cylinder. You must read and understand the following procedures for CO
2
cylinders before installation:
1. Install the CO
2
gas line tube to the regulator by attaching one end of the red tube to
the hose connection on the CO
2
regulator.
2. Secure the tube by using one of the self-locking black plastic snap-on clamps.
3. Insert a special washer into the regulator-to-cylinder attachment nut.
4. Attach the CO
2
regulator to the CO
2
cylinder by screwing the regulator nut onto the
cylinder valve and tightening with an adjustable wrench.
5. Remove the bolt with the nut from the cylinder retainer. Using two screws, attach it
inside the unit on the left side of the back wall. Holes are pre-drilled and screws are
included.
6. Slide the cylinder through the retainer and secure it with the bolt and the nut. Position
the cylinder this way so that you will be able to read the numbers on the gauges and
easily access the shut-off valve.
Installation of Accessories
1.
Once the unit has been positioned under the counter, install the beer tower assembly
and the mixed ball valve:
a.
Lower the beer tower through the hole in the counter and into the hole at the
top of the beer dispenser’s
upper surface. Be sure the tap is facing toward the
front of the machine.
b.
Take out the accessories of the mixed ball valve. Attach the transparent
hose to the beer outlet of the
mixed ball valve. (See Figure 5).
2.
Install CO
2
gas cylinder and CO
2
regulator valve:
a.
Fix the two CO
2
hose clamps on the red CO
2
tube (See Figure 6).
b.
Connect the ends of the red CO
2
tube respectively to the CO
2
intake port of the
mixed ball valve and the
round outlet of the
CO
2
regulator valve. Lock these connections
firmly with the two clamps on the red CO
2
tube (See Figure 7).
c.
Using the wrench, tighten the CO
2
regulator
table valve with the hex nut port to the gas
outlet of the CO
2
tank (See Figure 9).
Loading ...
Loading ...
Loading ...