Loading ...
IMPORTANT–Please Read and Follow!
2 3
• Before beginning, please read these instructions completely and carefully.
• Use caution during assembly to minimize scratches.
• Do not remove permanently affixed labels, warnings or plates from the product. This may
void the warranty.
• Please refer to the product Installation Instructions for more information on installing the
door panel.
• The installer should leave instructions with the customer who should retain for local
inspector’s use and future reference.
Parts Included
Required Tools
Handle Installation
To Install:
Installation with Wooden Full Overlay
Custom Door Front
1. Locate the wooden custom panel.
2. Using the illustrations on the next page, layout the handle location on the panels. It is
recommended that masking tape be placed where the two holes will be drilled to help mark
the hole placement and to prevent any damage to the door when drilling the holes.
3. The D3 handle will be mounted using (2) handle studs, (2) #8-32x1-3/8” phillip head screws,
and (2) #8-32 locknuts provided. Using the 3/16”(0.5 cm) drill bit, drill completely through
the door in the hole locations. Using the 9/16” (1.4 cm) bit, counter-bore four holes 1/2” (1.2
cm) deep max. on the BACKSIDE of the custom door panel. Attach the D3 handle to the
panel by aligning endcaps with studs, then tighten set screws on side of both endcaps. (See
figure 1)
4. See Section A-A for attaching stud.
Part Quantity
Electric Drill
3/16” (0.5 cm) Drill Bit
9/16” (1.4 cm) Spade or Forstner Bit (Counterbore)
Tape Measure
Hex Head Screw Driver
Phillips Head Screw Driver
Masking Tape and Pencil
Section A-A
Custom Door
FDSB, FDRB, FDFB
(Front View)
D3 Handle
D3 Handles
Handle Stud
#8-32x1-3/8” Phillip Head Screw
#8-32 Locknut
Installation Instructions
(1)
(2)
(2)
(2)
(1)
Figure 1
Loading ...
Loading ...