Loading ...
Loading ...
Loading ...
4.
INSTALLATION
A. Mounting
1. Fit the appropriate tube clamp around the front strut in the desired location. *Note: you
may need to remove bolts connecting the top to the front strut to complete this
step.
2. If a sliding adapter was supplied in your kit, you will need to loosely fasten it to the
soundbar, and then to the round tube clamps installed in step 1.
3. Ensure that the sound bar is in the desired location, then tighten all hardware.
B. Wiring
1. If installing on an electric vehicle, switch it into TOW mode. Carefully remove the
Positive (+) then Negative (-) battery wires.
2. A. If installing on a gas vehicle, wire the Negative (Black) wire to the Negative (-)
battery terminal and the Positive (Red) wire to the Positive (+) battery terminal.
B. If installing on an electric vehicle, wire the Negative (Black) wire to the Ground on
the DC-DC Converter and the Positive (Red) wire to the Positive (+) post on the DC-DC
Converter.
3. Route the thick Blue Aux In & Aux Out wires to your desired location. The Aux In is for a
music source that does not have Bluetooth capability. The Aux Out is to connect to an
optional amplied subwoofer, such as the STEALTH AS-10 or AS-6.
4. The Blue Remote Out wire provides +12V when the soundbar is powered on. This
may be used as a turn on signal for additional ampliers or for an optional amplied
subwoofer, such as the STEALTH AS-10 or AS-6.
5. Tie up all excess wires and reinstall the Positive (+) then Negative (-) battery wires. If
installing on an electric vehicle, switch it back into RUN mode.
Note: DC-DC Converter is required on electric vehicles to avoid damage to the
accessory and the vehicle.
Loading ...
Loading ...