Loading ...
Loading ...
Loading ...
Turnontheicemakerbyopeningthefreezerdoorand
loweringthewireshut-offarmasshown.Allow24hoursto
producethefirstbatchofice Discard the first three batches
of ice produced.
For normal ice production, set the switch on the front of the
ice maker to NORMAL. In the normal ice production mode,
the ice maker should produce approximately 7 to 9 batches
of ice in a 24-hour period,
For maximum ice production (on some models), if your
refrigerator has the maximum ice production feature, set the
switch on the front of the ice maker to MAX In max ice
production mode, the ice maker should produce
approximately 10 to 14 batches of ice in a 24-hour period.
i inn n
r'-i
MAX
NORMAL
Door Closing
1. Remove all shipping and packing materials,
2. Plug in refrigerator
& Move the refrigerator into its final position,
4. Place a level inside the refrigerator at the back of the top
sheffr
till
5. Remove the base grille. The two leveling screws are part of
the front roller assemblies which are at the base of the
refrigerator on either side,
6, Use ascrewdriver to adjust the rear rotfer leveling screws until
the refrigerator is level,
NOTE: Open and close both the refrigerator and freezer
doors after each adjustment.
,, Turn the rear roller leveling screw to the right to raise that
side of the refrigerator or turn the leveling screw to the left
to lower that side
ii........
To remove the base grille:
1, Open both refrigerator doors
2. Place hands along the ends of the grille, with your thumbs
along the top. Push in with your thumbs and puli up on the
bottom.
NOTE: Be sure to refasten the Tech Sheet behind the base grille
after cleaning
To replace the base grille:
1. Open the doors.
2. Line up the grille support tabs with the metal clips.
3. Push the grille firmly to snap it into place.
7, Check the door alignment after leveling the refrigerator,.
Door Alignment
If the doors are uneven after leveling the product, foltow the steps
below,
..... ,,,,,,lu
ii iiiiiii
n UllUl
Loading ...
Loading ...
Loading ...