Loading ...
Loading ...
Loading ...
7
www.KALORIK.com
JK 46084 - 200312
manufacturing process. When the appliance has cooled down, repeat
the process 3 times with fresh water, before rinsing.
OPERATING INSTRUCTIONS
• Always remove the kettle from the power base before filling it or
before any operation.
• Open the lid by pulling the lid handle out and fill the tank with
water, paying attention not to fill under the minimum mark or above
the maximum mark indicated on the water gauge of the kettle.
Note: do not use hot water to fill the kettle. Use only cold or room
temperature water.
• Close the lid by placing it back on and pressing down until it you
hear a click. Make sure it closes correctly.
• Make sure the spout filter is well in position, as else the auto-shut off
feature might not work.
• Put the kettle onto the power base, plug into the wall socket, and
turn the kettle on. To switch on, place the On/Off switch to the “I”
position (switch down). The power On indicator light will illuminate.
• Do not open the lid while the water is heating or boiling.
• When the water has boiled, the kettle will switch to Stand-by-Mode.
If required, the water can be boiled again by changing the On/Off
switch to the “I” position (switch down). The power on indicator light
will illuminate again and the water will re-boil.
• The kettle may be switched to Stand-by-Mode at any time by
switching the On/Off switch to the Off position (switch up).
IMPORTANT: Place the power switch into Off position and remove
the plug from the outlet when the kettle is not in use.
CAUTION: Make sure that the lid is closed and the filter is correctly and
securely fitted before switching on the appliance. Failure to do so will
cause the kettle not to switch off!
• For instant re-boiling, wait until water has cooled down and switch
on the appliance again.
• The kettle will not re-boil until the kettle is switched on again.
• The kettle may be stored on the power base when not in use.
• Always disconnect the power supply when not in use.
Loading ...
Loading ...
Loading ...