Loading ...
Loading ...
Loading ...
Tilt-Lock Unit (on some models)
If your cooktop is equipped
with a 3-in-1 unit, this unit is a
tilt-lock unit.
Tilt-lock units cannot
be removed.
You can lift a tilt-lock unit
upward about 6“ and it will lock
in the up position.
To reposition the tilt-lock unit:
●
Replace
the drip pan into the
recess in the cooktop.
● Put the trim ring in place over the
drip pan. The drip pan must be
under the trim ring.
● Guide the surface unit into place
so it fits evenly into the trim ring.
Plug-In Units
(on some models)
All units except the 3-in-1 unit (on
some models) are plug-in units.
Plug-in units can be removed.
Lift a plug-in unit about 1“ above
the trim ring—just enough to grasp
it—and you can pull it out.
Do not lift a plug-in unit more
than 1 inch. If you do, it may not
lie flat on the trim ring when you
plug it back in.
Repeated lifting of the plug-in
unit more than 1 inch above the
trim ring can permanently
damage the receptacle.
3eceptacle
I
I
Terminals
Drip Pan/Ring
To replace a plug-in unit:
● Place the drip pan/ring into
the surface unit cavity found on
top of the cooktop so the unit
receptacle can be seen through
the opening in the pan.
● Insert the terminals of the plug-in
unit through the opening in the
drip pan and into the receptacle.
● Guide the surface unit into place
so it fits evenly into the trim ring.
CAUTION
● Do not attempt to clean
plug-in surface units in an
automatic dishwasher.
● Do not immerse plug-in surface
units in liquids of any kind.
● Do not bend the plug-in surface
unit plug terminals.
● Do not attempt to clean,
adjust or in any way repair the
plug-in receptacle.
(continued next page)
11
Loading ...
Loading ...
Loading ...