Loading ...
Loading ...
Loading ...
WATER FILTER
WATER FILTER
It is recommended that you replace the water lter:
Approximately every six months.
When the water filter indicator
turns on.
When the water dispenser output
decreases.
When the ice cubes are smaller
than normal.
1. Remove the old water filter.
Lower or remove the top left shelf
to allow the water lter to rotate
all the way down.
Pinch the sides to open the
water lter cover.
NOTE: Replacing the water lter
causes a small amount of water
(around 1 oz. or 25 cc) to drain. Place
a cup under the front end of the water lter cover to collect
any leaking water. Hold the water lter upright, once it is
removed, to prevent any remaining water from spilling out of
the water lter.
Make sure to rotate the lter down completely before
pulling it out of the manifold hole.
Pull the water lter downward and turn it counter-
clockwise.
Before Replacing the Water Filter:
If the top shelf, located below the water lter, is in the
highest position, it will need to be removed prior to
replacing the water lter.
To remove any shelf–Tilt up the
front of the shelf
1
and lift it
2
.
Pull the shelf out.
2. Replace with a new water lter.
Take the new
water lter out
of its packing
and remove the
protective cover
from the o-rings.
With the water lter tabs in
the horizontal position, push
the new water lter into the
manifold hole and turn it
clockwise.
Rotate the water lter up into position and close the
cover. The cover will click when closed correctly.
3. After the water lter is replaced, dispense 2.5
gallons of water (ush for approximately 5 minutes)
to remove trapped air and contaminants from
the system. Do not dispense the entire 2.5 gallon
amount continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
NOTE: To purchase a replacement filter, visit your local
Sears store, or call 1-844-553-6667, You may also purchase
online at www.sears.com.
33
Loading ...
Loading ...
Loading ...