DRAPER 02080 Pneumatic Long Chassis Low Profile Jack, 40 Tonne

User Manual - Page 8

For 02080.

PDF File Manual, 12 pages, Read Online | Download pdf file

02080 photo
Loading ...
Loading ...
Loading ...
8
6.1 HANDLE ASSEMBLY FIG 1 & 2.
1. Remove the circlip  from the handle
securing pin and slide the pin out.
2. Insert the handle into the jack body
ensuring the handle is in the upright
position.
3. Re-fit the handle securing pin through the
jack frame & handle. Ensure circlip is
re-attached to the end of the pin.
4. Loop the black air hose around the handle
securing pin then fully push the hose into
the connector (fig.2).
5. Follow above procedure for transparent
hose (as label diagram ).
6.2 BLEEDING AIR FROM THE SYSTEM
Prior to operating the jack, the hydraulic circuit must be purged to expel any accumulated
air from the system.
1. Push the lever to the down position. Hold the lever in this position for a few seconds.
2. Without any load, continue to operate the jack. Ensuring the jack reaches the highest
point and returned to the lowest.
3. Repeat last step until the movement of the piston is smooth & consistent before using
with any load applied.
6. OPERATING INSTRUCTIONS


FIG.1
FIG.2
Loading ...
Loading ...
Loading ...