Loading ...
Loading ...
Loading ...
2
IMPORTANT: This appliance is not designed for stacking with any other appliance. Do not attempt to sit or stand on top of
your appliance as it is not designed for such use. You could injure yourself or damage the appliance.
IMPORTANT: Make sure that mains cable is not caught under the appliance during and after carrying / moving the appliance,
to avoid the mains cable becoming cut or damaged.”
When positioning your appliance take care not to damage your flooring, pipes, wall coverings etc. Do not move the appliance
by pulling by the lid or handle. Do not allow children to play with the appliance or tamper with the controls. Our company
declines to accept any liability should the instructions not be followed.
INSTALLATION INSTRUCTIONS
1. If possible, avoid placing the appliance near cookers, radiators or in direct sunlight as this will cause the compressor to
run for long periods. If installed next to a source of heat or refrigerator, maintain the following minimum side clearances:
From Ranges/stoves 4" (100 mm)
From Radiators/heaters 12" (300 mm)
From Fridges 4" (100 mm)
2. Make sure that sufficient room is provided around the appliance to ensure free air circulation. Ideally, A space of no
less than 100 mm (4” in) must be left around the freezer, and ensure you allow gaps as
shown in the below diagram.
3. The appliance should be located on a smooth surface.
4. It is forbidden to use the refrigerator outdoors.
5. Protection from moisture. Do not locate the freezer in moist space to avoid the metal
parts rusty. And do not spray water to the freezer, otherwise it will weaken the
insulation and causes current leakage.
6. Refer to "Cleaning and Care" section to prepare your appliance for use.
7. If the freezer is installed in unheated areas, garages etc., in cold weather
condensation may form on the outer surfaces. This is quite normal and is not a fault.
Remove the condensation by wiping with a dry cloth.
STARTING
Final Check
Before you starting to use the freezer, please check that:
1. The interior is dry and air can circulate freely at the rear.
2. Clean the interior as recommended under "CLEANING AND CARE".
3. Insert the plug into the wall socket and switch on the electricity supply，then the Red light is on. Avoid accidental
disconnection by taping over the switch. Green light will glow, and the compressor will start running.
4. You will hear a noise as the compressor starts up. The liquid and gases sealed within the refrigeration system may also
give rise to noise, whether the compressor is running or not which is quite normal.
5. If you going to store already frozen food open the freezer lid and check that the freezer has reached the correct
temperature. Then you can put in your already frozen food.
6. Do not load the appliance immediately after it is switched on. Wait until the correct storage temperature has been reached.
We recommend that you check the temperature with an accurate thermometer.
Important Notes:
• If there is a power failure do not open the lid. Frozen food should not be affected if the failure lasts for less than 20 hours. If
the failure is longer, then the food should be checked and eaten immediately or cooked and then refrozen.
• If you find that the lid of the chest freezer is difficult to open just after you have closed it, don’t worry. This is due to the
pressure difference which will equalize and allow the lid to be opened normally after a few minutes.
FREEZER OPERATION
Temperature adjustment
The temperature of the freezer is adjusted by means of the knob assembled on the thermostat. ”1、2、3、4、5” do not represent
a specific temperature. The smaller the No. the higher the temperature, whereas. So, position “5” is being the lowest
temperature.
Figures mean:
“OFF” Forced Shutdown Point
1—5：Frozen Interval （from 1 =@10 degrees F to 5 =@-20 degrees F )
Loading ...
Loading ...