Loading ...
Loading ...
Loading ...
Control Panel/Operation -- ZBD6400 & ZBD6500
l) is hw as h¢r
3. HI?_TED DRY When selected, turns tile (hTing heater and tan oil fl)r fhst drying. This option
will extend tile cycle by 30 minutes. When this is NOT selected, tile tim will
mrn on to dry your dishes without added heat--and energy is saved.
HEATED DRY is not awdlable on RINSE ONIY.
4. WATER TEMP-- This button prmides extra heat options to increase water temperature for
optimum [_eribrmance.
NORMAL
This is tile detault setting--, I)r°xides a wash and rinse with water temperatures
3 ° 5° -3o_
up to l. 1 F (55°C) in tile NORMAI, cxcle and 14: F (6. C) in POTS &
PANS.
HIGH
This water temp selection proxides a wash and rinse with water temperatures
3-o_ 5-o_
up to l. :) 1_ (57°C) in tile NORMAl. c)cle and 1: :) 1_ (68°(:) in POTS &
E__NS. Use this option for heaxiE soiled dishes. Cannot be used with RINSE
ONlY or CHINA CRYSTAl.
5, DELAY START--This option will allow )ou to dela) tile start time of any wash c) cle except
RINSE ONlY for up to 6 horn's.
• Select tile delay start time xou, want bx, I)ressim"_ tile DEIfl_Y START button. JVhfltiI)le Ilressim*"
will alternate the delta time between 2, 4 or 6 horn's and OFF.
Start a
wash load
To start the dishwasher, close tile door tmtil it locks in place. Tile last used cycle will be displayed.
To begin this cycle, push the START button. To select a diflbrent cycle, push the desired Cycle
Selection and Option buttons, and then press tile START button.
The door inust be closed and latched into place to select a cycle or an option.
To interrupt/pause a cycle, press the selected cycle button. The Status Indicators will flash.
CAUTION: Be careflfl when opening the door; the hot steam that escapes when the door is
opened may cause ii_juries. Stand back as wm open tile door and allow tile steam to
escape.
_ATTENT1ON : Faites attention lorsque xous O/l_,i'ez la porte, i,a _,al)etli" br6lante qui s'_chai)pe
lorsque vous ouvrez la porto pendant un programme de lavage peut causer des
b_ Olm'es. i,orsque wins ouwez la porte, reculez et laissez la wq)em" s'_chai)per de
l'appareil.
To restart the wash process, close the door until it locks in place. Re-press the cycle button. There
may be a time delay of iiI) to a Jew minutes, because tile temperature inside tile dishwasher needs to
stabilize befln'e it starts the wash cycle. Dm'ing this time the SENSING light will be on.
To cmlcel the cycle after it has started, press and hold the START/CANCEl, button for 3 seconds.
The dishwasher will then drain and the cycle indicator lights will flash. At this point a new wash cycle
can be selected. If a new cycle is not selected, all the Cycle Indicator lights will go out alier the
dishwasher drains. If you have selected a new wash cycle, remember to add more detergent to
tile detergent compartment if required.
Loading ...
Loading ...
Loading ...