Loading ...
Loading ...
Loading ...
.NOIRRUF C MO
WIRING YOUR F30-ATS:
30amp 125Vac Wiring
Ground = Bare copper wire or green
Neutral = White
Live/Hot = Black
Using the quick reference wiring guide on the lid of the ATS box, arrange the wires to be
fed into the ATS for connection at the corresponding terminals.
Generator in
Shore Power in
Line/feed out
Feed the wires through the punched out and installed 1/2” cable strains to enter the ATS box.
See below diagram for wiring layout.
Strip 4” of outer jacket from each of the incoming cables.
Strip 3/8” of jacket from each of the wire conductors.
Using the copper spade terminals which are supplied on the terminals of the F30-ATS relay,
crimp these to the ends on the incoming cables.
Connect the cables to the corresponding terminals shown on the installation directions on the
lid of the of the transfer switch.
Using your #2 philips head torque Screwdriver, tighten the terminal screws
to 14in-lb minimum and 18in-lb maximum
Connect the chassis grounding 10AWG wire to the grounding terminal block on the inside
of the transfer switch box. Use the 3/8” through hole to feed the wire through from the
outside of the box directly to the terminal block.
Using your #2 Square Head Torque Screwdriver, tighten the grounding block terminal
screws to 20in-lb minimum and 25in-lb maximum.
Loading ...
Loading ...
Loading ...