Loading ...
Loading ...
Loading ...
.
CONTROL PANEL
Electronic Control Panel & Remote Control
Note: This control panel display always shows the
room temperature in Fan Mode except when setting
the temperature and timer.
Normal Operating Sounds
• You may hear a pinging noise caused by water
hitting the condenser on rainy days, or when the
humidity is high. This design feature helps re-
move moisture and improve efficiency.
• You may hear the thermostat click when the
compressor cycles on and off.
• Water will collect in the base pan during rain
or days of high humidity. The water may over-
flow and drip from the outside part of the unit.
• The fan may run even when the compressor is
not on.
Power Button: Turn the air conditioner on and
off.
Digital Display: Will display set temperature when
the unit is in Cool, Dry, Auto, Sleep, Energy Saver
mode, and display current room temperature when
in Fan mode.
Temperature Set: Use these buttons on the control
panel or remote to increase or decrease the Set
Temperature.
Fan Speed: Use the fan speed button to
change the fan speed. Choose between high,
low, and quiet.
Mode Button: Press the MODE button to cycle
through the various modes: Cool, Dry, Fan, Auto,
Sleep, Energy Saver
Timer Set: Use these buttons on the control pan-
el and remote control to set the timer. Each press
of the ▲or▼ button will increase or decrease the
timer.
Auto-On Timer: When the air conditioner is off,
it can be set to automatically turn on in 1-24
hours at the previous set mode and fan settings.
To set the Auto-on Timer, press the TIMER but-
ton on the unit or remote control. Timer can be
set in 1 hour increment.
Auto-off Timer: When the air conditioner is on, it
can be set to automatically turn off in 1-24 hours.
To set the Auto-off Timer, press the TIMER button on
the unit or remote control. Timer can be set in 1 hour
increment.
Once timer is set, TIMER ON/OFF indicator on con-
trol panel will light up, the set temperature will also,
shown on digital display. To see the remaining time,
press TIMER button. To change the timer settings,
use the ▲or▼ on control panel or remote control.
During preview of timer setting, press TIMER button
once to display set time, press the button one more
time to cancel the settings.
Energy Saver Mode: Press the MODE button to
turn on Energy Saver Mode. In Energy Saver mode,
set the desired temperature and the unit will turn-off
once the room is cooled to that temperature. (The fan
will also be off.)
The unit will turn back on when the room
temperature rises above the set temperature.
The fan will cycle on and off automatically to save
energy.
Filter Reset: Press the FILTER RESET button to
reset the filter light. The light will illuminate every
250 hours of operation as a reminder to clean the
filter.
Signal Receiver: Point the remote control to the
air conditioner when sending instruction to the
unit.
Loading ...
Loading ...
Loading ...