Loading ...
Loading ...
Loading ...
OPTIONS DISH LOAD TYPES DESCRIPTIONS USE WITH:
For best d_ing results dry This option With the use of rinSe aid Will piovide the best All CYcles except Quick
ProDry dishes with heat _ drying perf0rmance. Cleanup and Rins e
L_.,,..2_L...S Only. Automatic with a!l
wash Cyc!es unless you
turn it off.
Tosanitize your dishes and
glassware in accordance
with NSF/ANSI Standard
184 for Residential
Dishwashers.
Raises the water temperature in the final rinse to
approximately 155°F (68°C). This high temperature rinse
sanitizes your dishes and glassware in accordance with
NSF/ANSI Standard 184 for Residential Dishwashers.
Certified residential dishwashers are not intended for
licensed food establishments.
The Sanitize or Sani Rinse option adds heat and time to the
cycle.
Sensor Wash, Heavy
Duty and Normal Wash.
Only these sanitization
cycles have been
designed to meet the
NSF/ANSI
requirements.
Loads Containing tough' InCreases the target water temperature during the wash senSor Wash, HeaVY
To run your dishwasher at
a later time or during off-
peak hours.
Delays the start of a cycle up to 4 hours.
Select a wash cycle and options. Press 4 Hour Delay. Press
START/RESUME. Close the drawer firmly.
All cycles, except Rinse
Only
Control Lock To avoid unintended use of To turn on Lock, press and h0!d ProDry for at least Anytime
your dishwasher, ar cycle 3 seconds.
When Control Lock is lit, a!! buttons are disabled. Ifyou press
any pad while your dishwasher is locked, the light flashes
3 times. The dishwasher drawer can be opened while the
controls are locked.
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the
cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle
will automatically compensate by adding time, heat and water as needed.
CONTROL PURPOSE COMMENTS
_'_/ To start or resume a If the drawer is opened during a cycle, a delay, orthe power is interrupted, the start/Resume
Wash Cyc e nd cator f ashes To restart the drawer open the draWer piess start/ResUme and € 0se the
drawer firmly within 4 seconds.!
To cancel wash
cycle
Close the drawer firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
drain completely. If the Cancel button is pressed a second time, the drawer will turn off.
@W_,hing TO follow the Clean indicator g!ows When a cYc!e is finished.
Dr,n progress and status
@ y9 '. ifv0U Select the sani Rinse option when the sani Rinse ovoid iS finished the sanitized indicator
_C!ean o1 your dishwasher glowsl If your diShWasher did'not proper!y sanitize your dishes the ligl_tflashes at the end of the
@sanitized cyc e cycle This can happen if the cycle is interrupted, or the water could not be heated to the required
IRinseAidLow temperature. The !ight goes off when you open and C!ose the drawer or press CANCEL:
_ Locked The rinse aid low indicator light glows when the rinse aid dispenser needs to be refilled.
Loading ...
Loading ...
Loading ...