Loading ...
Loading ...
Loading ...
100780 - 3100 PSI PRESSURE WASHER
OPERATION
17
OPERATION
Pressure Washer Location
This pressure washer must have at least 5 ft. (1.5 m) of clearance
from combustible material. Leave at least 3 ft.
(91.4 cm) of clearance on all sides of the pressure washer to
allow for adequate cooling, maintenance and servicing. Place
the pressure washer in a well ventilated area. DO NOT place the
pressure washer near vents or intakes where exhaust fumes could
be drawn into occupied or confined spaces. Carefully consider
wind and air currents when positioning pressure washer.
Before Starting the Engine
1. Turn the water supply ON.
2. Pull the trigger on the trigger gun to purge all air from the
pump and hose. This may take several minutes.
3. Do not start the engine until a steady stream of water is
flowing from the nozzle.
CAUTION
Never operate your pressure washer without water.
Starting the Engine
1. Make certain the pressure washer is on a flat, level surface.
2. Move fuel valve to the “ON” position.
3. Move the choke lever to the “CHOKE” position.
4. Pull the starter cord slowly until resistance is felt and then
pull rapidly. SEE NOTE.
5. As engine warms up, move the choke lever to “RUN”.
Loading ...
Loading ...
Loading ...