Loading ...
Loading ...
Loading ...
1
2
3
4
Adjusting the level of the appliance
Make sure that the appliance is level to close and seal
the door correctly. If the level of the appliance is correct,
the door does not catch on the sides of the cabinet. If
the door does not close correctly, loosen or tighten the
adjustable feet until the appliance is level.
Adhesive steam protection foil
If the worktop is removed, fit the steam protection onto
the front part of the kitchen cabinet benchtop.
The steam protection foil is not supplied with free-
standing models, but can be purchased from
Electrolux Spare Parts.
Water connection
Water inlet hose
Connect the appliance to a cold water supply.
Connect the inlet hose to a water tap with an external
BSP thread spout of 3/4”.
Inlet water supply
• Cold water pressure: 800 kPa max - 50 kPa min.
• Water flow rate 10 L / minute min.
• If cold water pressure is in excess of 800 kPa, a
pressure reducing valve should be used. Check for
leaks.
Caution! Always use new hoses when you
connect the appliance to the water mains. Old
hoses must not be used. The water inlet hose must be
examined at an interval of twelve months for
deterioration and replaced if necessary.
The water pressure must be in the limits (refer to 'Tech-
nical data'). Make sure that the local water authority
gives you the average mains pressure in your area.
Make sure that there are no kinks in the water inlet hose
and that the water inlet hose is not squashed or entan-
gled.
Fit the hose nut correctly to prevent water leaks.
Caution! Do not connect the appliance to new
pipes or pipes that have been not used for a long
time. Let the water run for some minutes, then connect
the inlet hose.
Water drain hose
The highest point of the drain hose must be no more
than 60 cm from the floor and must have a continuous
fall.
The drain hose can be lengthened using additional
lengths and connectors. These must be purchased
from Electrolux Spare Parts. The extension length must
not exceed 2 metres.
The drain hose must be free of kinks and obstructions.
Remove the sink plug when the appliance drains the
water to prevent that the water goes back into the ap-
pliance.
If you connect the water drain hose to a trap spigot
under the sink, remove the plastic membrane. If you do
not remove the membrane, remaining food can cause
a blockage in the drain hose spigot.
12
Loading ...
Loading ...
Loading ...