Loading ...
Loading ...
Loading ...
4
Preparing the rangehood for installation
Ensure the overhead cabinets are built according to Fig.5 (below).
Before drilling any holes, check that the area behind the surface to be drilled is clear of any
electrical cables or pipes etc.
Recirculated installation
If the rangehood is to be installed as a recirculated hood,
first ensure the cabinets are built according to Fig. 5 below:
1
Do not remove the knockouts shown in Fig.4. These are
removed for ducted options only.
2
Remove Cover Tape “A”. See Fig.4.
Note: for recirculation, please purchase a charcoal
filter (R103794C).
Please proceed to steps 3 and 4 below.
Ducted installation
If the rangehood is to be installed as a ducted hood:
1
Remove the appropriate knockout to suit rear or top
venting, as shown in Fig.4
2
Do not remove Cover Tape “A”. See Fig.4. This is removed
for recirculating only.
3
If an 80mm handle is not installed, remove front fascia
“B” by undoing the 3 screws on the fascia (see Fig. 4).
4
Replace front fascia “B” with a replacement front panel “C”,
constructed of same or similar material as the surrounding
cupboard doors. See Fig. 5 for height of panel.
Mounting the rangehood
The rangehood can be mounted in two ways, top or sides.
Before commencement, unpack the rangehood and check that it functions correctly.
Mounting to underside of cupboard
Fix the rangehood to a shelf mounted at the right height in your wall units, by drilling 4 holes,
5 mm in diameter, (see Fig.6) and fixing with the 4 screws supplied (found in the bag labelled
“TOP FIXING”).
Installation instructions
Knockouts (remove for ducted only)
Fig.4 Preparing for install
Wall
Cupboard
Door
For top ducting cut hole to suit size
Dimensions shown are for UNIDUCT
Drill 5 mm holes
Fig.6 Mounting to
underside of cabinetry
Filtered air
Cooking fumes
Fig.5 Panel heights
Loading ...
Loading ...
Loading ...