Loading ...
Loading ...
Loading ...
26 27
Storage and transport
Storage
After cleaning the unit thoroughly, store mower in a dry room and allow the motor to cool
down.
- Move the handle to the storage position.
(Fig. M)
- Store the product with the handle detached if required.
NOTE:
Remove the battery pack. Ensure cables are not trapped when folding/unfolding the
handle. If stored vertically make sure the mower is positioned in a corner so that the blade is
facing inwards against a wall and the machine is secure to prevent it falling over.
Transport
Use the original packaging to ship whenever possible.
MAINTENANCE AND STORAGE
TROUBLESHOOTING
WARNING:
Before performing any repair work, always ensure that the battery
pack has been removed.
WARNING:
Always wear heavy duty gloves when adjusting or cleaning, especially
when handling sharp objects.
Fault/malfunction Cause Remedy
Mower fails to start
Battery is not correctly inserted Remove the battery and reinsert
Mower standing in high grass
Start motor on shorter grass or
already mowed area, change cutting
height if necessary
The mower housing is clogged
Remove battery pack and clean
housing so that the blade can move
freely
Battery has no power Check and recharge battery
Mower is over loaded Re-start the mower on shorter grass
Mower is overheated
Wait until the temperature cools
down
Handle position is in the
disactive angle
The mower could only started by the
angle between 17°-70°
Mower stop working /
loses power
Cutting height is incorrect Adjust the cutting height
Cutting blade is worn or
damaged
Replace with new blade from dealer
service centre
Battery performance
decreasing
Check the battery performance and
charge it if necessary
Handle position is in the
disactive angle
The mower could only started by the
angle between 17°-70°
Mower vibrating at
higher speed
Cutting blade is loosened
Tighten the blade bolt
Blade is loosened /incorrectly
tted
Balance the blade by grinding each
cutting edge until equal
Mower cuts unevenly
The blade is damaged.
Blade is assembled incorrectly
Sharpen the blade or replace.
Re-assemble blade correctly
Loading ...
Loading ...
Loading ...