Loading ...
Loading ...
Loading ...
Avoid Servioe
Checklist
Before calling for service, review this list, It may save both time and expense, The list includes
common occurrences that are not the result of defective workmanship or materials in this dryer,
OCCURRENCE POSSIBLE CAUSE SOLUTION
_ nat start. Electrical power cord is not securely plugged Make sure the plug fits tightly in wall outlet.
in or plug may be loose.
House fuse blown or circuit breaker tripped. Reset circuit breaker or replace fuse.
Make sure electrical line is not overloaded and the dryer is
on a separate circuit.
Thermal limiter tripped. Call authorized service person for replacement.
Dzyer _ but won't heat. There are 2house fuses in the dryer circuit, lf Replace fuse.
1 of the 2 fuses is blown, the drum may turn
but the heater will not operate.
Gas supply valve is not open (gas models). Check to make suresupply valve isopen. SeeINSTALLATION
INSTRUCTIONSfor procedure.
Dryer does not have enough air supply to See INSTALLATION INSTRUCTIONS.
support the burner flame (gas models).
LPgas supply tank isempty or there has been Refill or replace tank.
a utility interruption of natural gas (gas
models). Dryer should heat when utility service is restored.
cycle takes too lcr_, Lint screen is clogged with lint. Make sure all lint has been removed from the dryer lint
cutside of the dryer feels screen before starting each cycle.
too _dc or arel:Ls hat.
Exhaust duct requirements have not been Exhaustduct must be at least 4 inches in diameter and made
met. of rigid or flexible metal.
When in place, the duct must have no more than two 90°
bends and must not exceed length listed in INSTALLATION
INSTRUCTIONS.
Electricdryerisconnectedtoa 208voltcircuit. Drying time will be 20% longer than drying on a 240 volt
circuit.
Drying procedures have not been followed. See _J_cj z:_ec_s, page 4.
Outside exhaust hood or exhaust duct may Clean out any obstruction.
be clogged or restricted.
High humidity. Use a dehumidifier near the dryer.
Excessive wzizb,ZJr_j. Dryer isoverloaded. Do not overload. See Drying R_ocedures, page 4.
Items left in dryer too long. Remove items as soon as cycle ends.
Insufficient sorting of items. See Drying _es, page 4.
Drying temperature too high. Follow fabric care label instructions.
Scratching or chipping of the
drun finish.
Foreign objects such as coins, pins, clips or
buttons are inside the dryer.
Permanently attached items such as belt
buckles, zippers and fasteners may be hitting
the inside of the drum.
Always remove foreign objects from pockets before
laundering. Remove objects from drum and restart dryer.
It may be necessary to baste a scrap of material securely
around ornaments before drying to prevent scratching and
damage to the dryer.
Drum damage caused by foreign objects or
pertly attac/qeditems is not covered by the
warranty.
Loading ...