Loading ...
Loading ...
Loading ...
Setting Surface Controls
Sizes of the Surface Gas
Burners
Your appliance is supplied with
the following 3 different surface
gas burners:
* Simmer Burner (5,000 BTU)
* 2 (or 3 on 36" models)
Standard Burners (9,500
BTU)
* Power Burner (14,200 BTU)
When setting up the range for
the first time, make sure that
the correct Burner Caps and
Burner Grates are located as
shown in Figure,
Burner Ca
(Standard
Standard _.
Burner He
...................(9,500 BT
Burner Cap
(Standard)
Standard
Head
BTU)
Standard
Burner Head
(9,500 BTU)
Center Rear Burner
Grate (36" Models only)
Standard Burner Cap
(36" Models only)
Check Burner Cap Placement Before
Operating the Surface Burners
To prevent flare-ups and avoid creation of harmful by-
products, do not use the cooktop without all burner caps
properly installed to insure proper ignition and gas flame size,
It is very important to be sure that all surface burner caps
and burner grates are properly installed and in the correct
locations BEFORE operating the cooktop burners,
Burner Cap_.,_
_1_1 iiii!i_!Uiii}diiX_ii_;i;
Burner Head-,_._ "_ _X,Burner Cap Lip
Remember:
• Always keep surface burner caps in place whenever
using a surface burner.
When placing the burner caps, be sure that all burner caps
are seated firmly and rest level on top of burner heads.
For proper flow of gas and ignition of burners DO NOT
allow spills, food, cleaning agents or any other material to
enter the gas orifice port opening.
Round Style Burners
The burner cap lip (See Fig. 1) should fit snug intothe
center of burner head and rest level. Refer to Figs. 2 & 3
for correct and incorrect burner cap placement. Once in
place, you may check the fit by gently sliding the burner cap
from side to side (Fig. 4) to be sure it is centered and firmly
seated. When the burner cap lip makes contact inside the
center of the burner head you will be able to feel it. Please
note that the burner cap should NOT move off the center of
the burner head when sliding from side to side.
7
Fig. 1
Correct Burner Cap Incorrect Burner Cap
Placement Placement
Fig. 2 "_ Fig. 3
Fig. 4
Loading ...
Loading ...
Loading ...